first time posting a picture in here so im not sure if it worked, using photo bucket, anyways i bought an HMDX portable speaker, or amp. it was like the one in the reference section done by bungle, but my circuit was different. it had the same components and all, but it was rearranged differently and the board was larger. so i went over it and found the alternative pins for it all. if my trim works the circuit will go down to about the same size as a 3ds cartridge. i ended up cutting more then the lines shown in the picture, i went above the red line on the tact on the right and cut around the tact of the left side. i also forgot to add the two joints that you need to rewire for the trace near the power pins and the cap. although its just ground and 5v which i have two pins. i used continuity and found that gnd and 5v pins are still connected together on my board and just need to do that mod to remove the use of the power button on this thing. im gonna leave it on there for now and just rewire the tacts and other junk that i removed and will have it all tested soon. NOTE: i made sure to check around the components for extra traces and made sure i didn't severe any. its all sanded well and im gonna clean it up and have some photos of this soon to show how it looks and if it works. if it does ill try getting a video uploaded to show proof.
onelonel: Siamo un gruppo indipendente di professionisti IT specializzati e tecnici di database. Siamo specializzati nella produzione di passaporto, SSN, licenza, carte I.D, certificati di nascita, diplomi e molti altri documenti di altissima qualità e altri servizi
Apr 10, 2019 20:26:24 GMT -6